CSW-001: Difference between revisions
Jump to navigation
Jump to search
(speculation) |
m (trying to standarize switch board pages sections) |
||
| Line 1: | Line 1: | ||
= Description = | |||
Part number: 1-871-871-21 | *Part number: 1-871-871-21 | ||
*[[CSW-001]] is a [[Switch boards|switch board]] compatible with PS3 models: | |||
**[[CECHAxx]], [[CECHBxx]] with motherboard [[COK-001]] | |||
**[[CECHCxx]], [[CECHExx]] with motherboard [[COK-002]] | |||
<gallery> | <gallery> | ||
| Line 10: | Line 11: | ||
</gallery> | </gallery> | ||
= Pinout = | |||
{{CSW-001 pinout}} | {{CSW-001 pinout}} | ||
*Eject LED should be connected to BD controller [[CXD5063AGG-1]] | *Eject LED should be connected to BD controller [[CXD5063AGG-1]] | ||
*Other signal pins should be connected to syscon [[CXR713120-xxx]] series | *Other signal pins should be connected to syscon [[CXR713120-xxx]] series | ||
= How it works = | |||
= Modding = | |||
{{Console Components}}<noinclude>[[Category:Main]]</noinclude> | {{Console Components}}<noinclude>[[Category:Main]]</noinclude> | ||
Revision as of 02:28, 20 July 2017
Description
- Part number: 1-871-871-21
- CSW-001 is a switch board compatible with PS3 models:
Switch board CSW-001 (PCB top view)
Switch board CSW-001 (PCB bottom view)
CSW-001 1-871-871-11
.jpg){kind=small}
.jpg){kind=small}
Pinout
| Pin | Name | Connected to | Description | |
|---|---|---|---|---|
| On Motherboard | On Switch board | |||
| 1 | GND | GND | GND | Ground |
| 2 | SW_PWM | Syscon pad N9 | Testpad ? | FREQ. Intended to send a PWM signal to the switch board ? |
| 3 | RMC_IN | Syscon pad R10 Service Connector (CN4009) pin 17 |
Testpad ?. NC | ReMote Control INput The IR receiver component is missing in the Switch board but existed in some PS3 prototypes that was using SIRC protocol and SERV_SIRCS |
| 4 | POW_SW | Syscon pad B12 | Power Switch  |
|
| 5 | EJECT_SW | Syscon pad A12 | Eject Switch  |
|
| 6 | POW_LED | Syscon pad M7 | Green led | |
| 7 | STBY_LED | Syscon pad N7 | Red led | |
| 8 | BD_LED | BluRay connector (CN3221) pin 50 | Blue led | |
| 9 | GND | GND | GND | Ground |
| 10 | +5V_EVER | Power Supply connector (CN6005) pins 4 and 5 | VCC | 5V Standby |
- Eject LED should be connected to BD controller CXD5063AGG-1
- Other signal pins should be connected to syscon CXR713120-xxx series
How it works
Modding
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
