Revision as of 17:23, 30 January 2019

DECR-1400(A/J)

BDemu Harddrive
Submodels	DECR-1400A / DECR-1400J
Type	0x09
Motherboard	DEB-001
Flash Storage	1x 16MB NOR
CELL BE / RSX	45nm / 65nm
South Bridge	CXD2984GB
Syscon	CXR714120-302GB
CP	-
GameOS Harddrive	160GB
Bluray Drive	YES
HDMI Ports	1
OtherOS	PARTIAL (Until System Firmware 3.20 included)
USB Ports	4
GbLAN Ports	2 (1 for debugger)
Flash Readers	No
PS2 mode	NO (No Emotion Engine or Graphic Synthesizer on the motherboard, no ps2emu software in the official firmware)
PS1 mode	NO (No ps1emu software in the official firmware)
SA-CD	NO
WiFi802.11b/g	YES
SKU Release date	June, 2009
downgradeable Min. praxis	260.001
Other	Uses the same metldr/bootloader builds as CECH-2000 units.

Model	Type	Board	Flash	SB	Syscon	CP	BDemu HDD	GameOS HDD	Bluray Drive	HDMI Ports	OtherOS	CELL BE	RSX	USB Ports	GbLan Ports	Flash Readers	Support: PSP PS2 PS1	SA- CD	WiFi 802.11 b/g	SKU Release date	SDK/FW support	downgradeable Min. praxis	Other
DECR-1000(A/J)	0x01	TMU-520	2x 256MB NAND	CXD2973AGB-4	CXR713F120A	TCP-520	400GB	400GB	?0x00?	2 (NO CEC)	NO	90nm	90nm	4 + 2 extra	4 (1 for dbg.)	YES	?YES? NO NO	NO	YES	2006	=>1.0.0 or =>2.3.0 (since 1/2009)	0.08	contains prototype components, hardware is identical to DEH-R1040 with a different label/model name.
DECR-1400A/J	0x09	DEB-001	1x 16MB NOR	CXD2984AGB	CXR714120-302GB	(via SB)	-	160 GB	?0x0A?	1 (NO CEC)	PARTIAL	45nm	65nm	4	2 (1 for dbg.)	NO	?YES? NO NO	NO	YES	6/2009	=>2.6.0	=>2.60	same case as retail PS3

Differences between the 1000 and 1400:

DECR-1000:
- Gb-DEVLAN is connected to the Communication Processor
- With a pre (or equal to) 0.85.010 bootrom you do have two HDMI outputs.
- Not all DECR-1000 are equal! Despite Sony's documentation claiming otherwise, DECR-1000 units with RSX rom version b07 and above such as refurbished/serviced units (and perhaps some others that have not been encounter) are not capable of running any firmware lower than 1.60 (from sdk 160.008) this is because the rom version is unknown/unsupported in older lv1 which will fail to initialize the RSX hardware and will cause lv1 to output a "rsx rom abort!" message, this will in turn create an exception early in lv2 boot process as it tries to use the RSX and creates a hard brick several RSX related errors such as "lv2(2): # __rsxaudio_intr_create_thread 983 ffffffff" or "graphics error 512 : 00012625 c221bbb0" ; "lv2(2): page fault handler (DSI): invalid access address 0x795d00e8!".

@@ Line 63: / Line 63: @@
 | {{NO}} (No [[Emulation#ps1emu|ps1emu software]] in the official firmware)
 |-
-! [[SA-CD]]
+! [[Super_Audio_CD_(SACD)|SA-CD]]
 | {{NO}}
 |-
@@ Line 70: / Line 70: @@
 |-
 ! SKU Release date
-| June 2009
+| June, 2009
 |-
 ! [[Template:Metbootldr|downgradeable Min. praxis]]