CSW-001: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
(speculation) |
||
| Line 11: | Line 11: | ||
{{CSW-001 pinout}} | {{CSW-001 pinout}} | ||
*Eject LED should be connected to BD controller [[CXD5063AGG-1]] | |||
*Other signal pins should be connected to syscon [[CXR713120-xxx]] series | |||
{{Console Components}}<noinclude>[[Category:Main]]</noinclude> | {{Console Components}}<noinclude>[[Category:Main]]</noinclude> | ||
Revision as of 06:38, 19 July 2017
| This article is marked for rewrite/restructuring in proper wiki format. You can help PS3 Developer wiki by editing it. |
Part number: 1-871-871-21
Panel for PS3 models FAT CECHA, B, C, E
Switch board CSW-001 (PCB top view)
Switch board CSW-001 (PCB bottom view)
CSW-001 1-871-871-11
.jpg){kind=small}
.jpg){kind=small}
| Pin | Name | Connected to | Description | |
|---|---|---|---|---|
| On Motherboard | On Switch board | |||
| 1 | GND | GND | GND | Ground |
| 2 | SW_PWM | Syscon pad N9 | Testpad ? | FREQ. Intended to send a PWM signal to the switch board ? |
| 3 | RMC_IN | Syscon pad R10 Service Connector (CN4009) pin 17 |
Testpad ?. NC | ReMote Control INput The IR receiver component is missing in the Switch board but existed in some PS3 prototypes that was using SIRC protocol and SERV_SIRCS |
| 4 | POW_SW | Syscon pad B12 | Power Switch  |
|
| 5 | EJECT_SW | Syscon pad A12 | Eject Switch  |
|
| 6 | POW_LED | Syscon pad M7 | Green led | |
| 7 | STBY_LED | Syscon pad N7 | Red led | |
| 8 | BD_LED | BluRay connector (CN3221) pin 50 | Blue led | |
| 9 | GND | GND | GND | Ground |
| 10 | +5V_EVER | Power Supply connector (CN6005) pins 4 and 5 | VCC | 5V Standby |
- Eject LED should be connected to BD controller CXD5063AGG-1
- Other signal pins should be connected to syscon CXR713120-xxx series
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
