Template:DSW-001 pinout: Difference between revisions
Jump to navigation
Jump to search
(moved from Switch boards page) |
mNo edit summary |
||
| Line 1: | Line 1: | ||
{| class="wikitable sortable" | {| class="wikitable sortable" | ||
|+DSW-001 Pinout {{ed right|DSW-001 pinout}} | |+[[DSW-001]] Pinout {{ed right|DSW-001 pinout}} | ||
! rowspan="2" | Pin !! colspan="2" | Signal/Connected to !! rowspan="2" | Description | ! rowspan="2" | Pin !! colspan="2" | Signal/Connected to !! rowspan="2" | Description | ||
|- | |- | ||
Revision as of 05:24, 19 July 2017
| Pin | Signal/Connected to | Description | |
|---|---|---|---|
| On Motherboard | On Switch board | ||
| 1 | pin13 @ Syscon | Pogo Pin | Only This line have pogo pin @ switchboard, seems that it is a service pin. |
| 2 | pin12 @ Syscon | 4x CONTOUR LEDs | Not used by default. On Switch board is connected to a transistor driving 3 LEDs TWO BLUE AND ONE RED. |
| 3 | pin11 @ Syscon | 4x WHITE LEDs | Inner light for power and eject switches. |
| 4 | pin110 @ Syscon | POWER switch | Sink to ground to activate. |
| 5 | pin111 @ Syscon | EJECT switch | Sink to ground to activate. |
| 6 | pin5 @ Syscon | GREEN led | Connects to bottom-left corner pin (green gnd) of dual red/green LED over power switch. |
| 7 | pin6 @ Syscon | RED led | Connects to top-left corner pin (red gnd) of dual red/green LED over power switch. |
| 8 | pin13 @ BD_Connector | BLUE led | Connects to blue LED over eject switch. |
| 9 | GND | GND | Ground |
| 10 | VCC | VCC | +5V DC VCC |
- above top panel view port behind pcb. resistors was not tested.