SPIway
Jump to navigation
Jump to search
SPIway
SPIway - Teensy++ 2.0 SPI flasher for PS4
Source: NORway on github
Pinout
8-Pin | 16-pin | Usage | Teensy++ 2.0 SPIway |
Description |
---|---|---|---|---|
- | 1 | SIO3 | B5 | 8pin: Not Available - not used / 16pin: Serial Data Input & Output (for 4xI/O read mode) |
8 | 2 | VCC | +5V pad | +3V DC Power Supply |
7 | 3 | HOLD#/RESET# | B6 | 8pin: Hold, to pause the device without deselecting the device / 16pin: Hardware Reset Pin Active low |
- | 4 | NC | NC | No Connection |
- | 5 | NC | NC | No Connection |
- | 6 | NC | NC | No Connection |
1 | 7 | CS# | B0 | Chip Select |
2 | 8 | SO/SIO1 | B3 | Serial Data Output (for 1 x I/O) or Serial Data Input & Output (for 2x I/O or 4x I/O read mode) |
3 | 9 | WP#/SIO2 | B4 | Write Protection: connect to GND or Serial Data Input & Output (for 4x I/O read mode) |
4 | 10 | GND | GND | Ground |
- | 11 | NC | NC | No Connection |
- | 12 | NC | NC | No Connection |
- | 13 | NC | NC | No Connection |
- | 14 | NC | NC | No Connection |
5 | 15 | SI/SIO0 | B2 | Serial Data Input (for 1 x I/O) or Serial Data Input & Output (for 2x I/O or 4x I/O read mode) |
6 | 16 | SCLK | B1 | Clock Input |
Use short wires, esp. if you are not adding the 0.1µF capacitor between ground and vcc as close as possible to the chip
Changelog
- v0.10
- Initial release
- Support for Macronix MX25L25635FMI-10G and MX25L25635FZ2I-10G
- v0.20
- Added README
- Added support for Macronix MX25L1006E
- Added support for Winbond W25X10CL
- v0.30
- Added support for Winbond W25Q80BV (thx to "Socketz"!)
Usage Examples
|