Template:DSW-001 pinout
Jump to navigation
Jump to search
| Pin | Signal/Connected to | Description | |
|---|---|---|---|
| On Motherboard | On Switch board | ||
| 1 | Syscon SW2-30x, pin 13 | Pogo Pin | Only This line have pogo pin @ switchboard, seems that it is a service pin. RMC_IN ?. Intended to reset syscon ? (syscon input ?) Also connected to a pin of a Service Connectors ? |
| 2 | Syscon SW2-30x, pin 12 | 4x CONTOUR LEDs | SW_PWM ?. Permanently inactive by default. On Switch board is connected to a transistor driving 3 LEDs: TWO BLUE AND ONE RED. |
| 3 | Syscon SW2-30x, pin 11 | 2x WHITE LEDs, ground pins | Inner LEDs for EJECT button backlight |
| 2x WHITE LEDs, ground pins | Inner LEDs for POWER button backlight | ||
| 4 | Syscon SW2-30x, pin 110 | POWER switch  |
Sink to ground to activate. |
| 5 | Syscon SW2-30x, pin 111 | EJECT switch  |
Sink to ground to activate. |
| 6 | Syscon SW2-30x, pin 5 | GREEN led | Connects to bottom-left corner pin (green gnd) of dual red/green LED over power switch. |
| 7 | Syscon SW2-30x, pin 6 | RED led | Connects to top-left corner pin (red gnd) of dual red/green LED over power switch. |
| 8 | BD_Connector, pin 13 | BLUE led | Connects to blue LED over eject switch. |
| 9 | GND | GND | Ground |
| 10 | CN101 Power Supply, pin1 ? | VCC | +5V DC VCC |
- above top panel view port behind pcb. resistors was not tested.