Talk:Switch boards
PS3 2000 series Power Eject boards, enabling contour leds talk
.jpg)
.jpg){kind=link}
This is a temporal section to discuss the simplest/easyer/safest/better way to make this mod, and the posible variations
The drawings at the right are a first sketch to discuss how to improve the drawings itself or the circuit, and are intented to replace the photos of this section in front page: http://www.ps3devwiki.com/wiki/Power_Eject_boards#Modding
- Light rays bouncing photo (this goes first because is easy to discuss)
- I could not find a better one where the first bouncing surface is more visible, this first surface is the most important but also the curve for the next bounces, is good to cover this with a mirror sticker (by sticking it in the case, this way the glue layer is at the other side)... no photo of this sticker
- Is barelly visible the light ray starts in verticall, and after the first bounce is in horizontal... arrows didnt helped
- Circuit squematic photo
The cutted trace in pin1 is just because the board was designed to be controlled this way, even if is not in retail models is possible that exist a prototype with it, also is needed to be 100% sure the pin goes nowhere (is posible the trace goes to an internal layer of the motherboard not visible in the surface and emerge again in a syscon pin)
The cutted trace in pin 3 to disable the 4 white leds for power eject buttons backlight is just a paranoid meassure to controll the total current of the board (you are adding 4 leds, so other 4 "needs" to be disabled)
The transistor base pin goes in-line with the other unpopulated transistor base pin, both does the same function at the same time, each transistor is in chargue of 2 leds with a common capacitor (the transistor opens/closes the leds ground lines, and when the line is opened the capacitor works as an "electricity buffer" creating a "fade out" effect while is discharguing). These transistors are "isolating" the subcircuit at his left
The unpopulated resistors values are dependant of the leds added, so no need to add the values to the drawing