Move Motion Controller

Components

• Model nº
  • CECH-ZCM1U (bought in ?)
  • CECH-ZCM1E (bought in europe)

Some photos of a dissassembled move controller ---> http://www.ifixit.com/Teardown/PlayStation-Move-Teardown/3594/1

ARM STM32F103 VBT6 Y (32bit MCU)

U19
http://www.st.com/mcu/devicedocs-STM32F103VB-110.html

Y5250H 2029 K8QEZ (Gyro?)

alt.no.: Y5250H 2005 4Y84AQ
alt.no.: Y5250H 2024 GPECQ
U14

Kionix KXSC4 10227 2410 (Accelerometer)

alt.no.: Kionix KXSC4-XLU 90831 3909
alt.no.: Kionix KXSC4 10115 2010
U12
http://www.kionix.com/

Texas Instruments BQ24080 (1-cell Li-Ion Charger)

alt.no.:BRO 01J PDH2
alt.no.:BRO 04K 0948
U1

TPS63030 (High Efficient Single Inductor Buck-Boost Converter)

alt.no.:CEE TI J 04P0
U6

Cambridge Silicon Radio BC4RE A16U (Bluetooth transmitter)

U8?
http://www.csr.com/products/technology/bluetooth

AKM AK8974 (three-axis Electronic Compass -MEMS)

alt.no.:AKM8974 948D
alt.no.:AKM8974 008F
U13
http://www.chipworks.com/seamark.aspx?sm=s4%3BDatedfl11%3BDevCategory12%3BMEMS+Devicesm12%3BReleaseMonthm10%3BDeviceTypefl10%3BReportCode12%3BEXR-0908-802&cw=detail2

Li-Ion (Battery Pack)

4-168-108-01 / LIS1441
3.7V 1380 mAh
(typ 1520mAh)
Charge Current: 1.4A
Charge Voltage: 4.25V

LED2

6 pins surface mounted RGB 2^24

• Soldered to the board with a ribbon cable (no connectors) with 4 lines marked as:
  • LED_B
  • LED_G
  • LED_R
  • LED_4R5 (VDD line)

External Conectors

Mini-B USB connector

Standard 5 pins

http://pinoutsguide.com/Slots/USB_pinout.shtml

Move Charging Station Pads

A little PCB with no traces that works as a support for 2 copper pads connected to the main board with 2 wires black/red (no connectors) http://www.youtube.com/watch?v=TkPFKrlWWwk

Move Sharp Shooter connector

8 pins custom made ? (smaller than the Mini-B) The connector is soldered in a "children board" and connected with the "main board" with a 12 traces ribbon cable. Only 4 of this lines are used for data signals (each line is protected with a resistor and a diode in the children board) + 1 line that seems to be common and is much more wide (probably volts or ground)

• This connector is used to communicate with the Move Sharp Shooter gun. The buttons, trigger, etc... of this gun can send signals to the move controller