Pinout: Difference between revisions
Jump to navigation
Jump to search
(Added locations of UART and some undocumented pins, as deduced by PCB layers photos and "File:Vita-1000-uart.png" from Henkaku Wiki, available under CC-BY 3.0. Sources: [1] https://wiki.henkaku.xyz/vita/File:Vita-1000-uart.png) |
m (Swapped chip orientation, now pin's function makes more sense. Data taken from publicly available source: https://www.intersil.com/content/dam/Intersil/documents/isl9/isl9110-12.pdf) |
||
| Line 34: | Line 34: | ||
| 14 || GND | | 14 || GND | ||
|- | |- | ||
| 15 || | | 15 || Mode switch of ISL9110IRTAZ buck-boost switch. Logic input, high for auto PFM mode. Low for | ||
forced PWM operation (less noise, according to vendor). | |||
|- | |- | ||
| 16 || GND | | 16 || GND | ||
Revision as of 22:43, 20 August 2018
Multi-use port
| Pin | Signal |
|---|---|
| 1 | Another voltage input? |
| 2 | Another voltage input? |
| 3 | GND |
| 4 | Audio output |
| 5 | Audio output |
| 6 | UART RX (CPU/Syscon) |
| 7 | UART TX (CPU/Syscon) |
| 8 | UART CTS (CPU/Syscon) |
| 9 | UART RTS (CPU/Syscon) |
| 10 | ? |
| 11 | headset control GND |
| 12 | headset control data / mic |
| 13 | Unknown, connected to Wolfson Micro WM1803E DAC |
| 14 | GND |
| 15 | Mode switch of ISL9110IRTAZ buck-boost switch. Logic input, high for auto PFM mode. Low for
forced PWM operation (less noise, according to vendor). |
| 16 | GND |
| 17 | +5V charge input |
| 18 | +5V charge input |
| 19 | GND |
| 20 | USB D- |
| 21 | USB D+ |
Accessory Port
Accessory Port - mstrp1
Accessory Port - mstrp2
Accessory Port - mstrp3
Accessory Port - mstrp4
| Pin | Signal |
|---|---|
| 1 | VCC |
| 2 | D- |
| 3 | D+ |
| 4 | N/C (floating?) |
| 5 | GND |
EHCI
The accessory port found only on the original Vita models is a custom port USB interface. The port must be activated in software and so far, there does not seem to be any official public software that uses it. As of firmware 1.69, all APIs that reference the accessory port are permanently disabled.
The only documented usage of this port is from an FCC filing for the PDEL-1001 development unit. It seems that some dongle attached to the device is used as part of their hardware testing framework.
The port appears to be the same as used on the Panasonic K1HA14AD0001.