Editing Pinout
Jump to navigation
Jump to search
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 34: | Line 34: | ||
| 14 || GND | | 14 || GND | ||
|- | |- | ||
| 15 || | | 15 || Mode switch of ISL9110IRTAZ buck-boost switch. Logic input, high for auto PFM mode. Low for | ||
forced PWM operation (less noise, according to vendor). | |||
|- | |- | ||
| 16 || GND | | 16 || GND | ||
Line 49: | Line 50: | ||
|} | |} | ||
=== Accessory Port | === Accessory Port === | ||
<gallery> | <gallery> | ||
File:Accessory Port - mtrp1.png|Accessory Port - mstrp1 | File:Accessory Port - mtrp1.png|Accessory Port - mstrp1 | ||
Line 57: | Line 58: | ||
</gallery> | </gallery> | ||
{| class="wikitable" | {| class="wikitable" | ||
! Pin | ! Pin || Signal | ||
|- | |- | ||
| 1 | | 1 || VCC | ||
| | |||
| | |||
|- | |- | ||
| 2 | | 2 || D- | ||
| | |||
| | |||
|- | |- | ||
| 3 | | 3 || D+ | ||
| D | |||
|- | |- | ||
| 4 | | 4 || N/C (floating?) | ||
| | |||
| | |||
|- | |- | ||
| 5 | | 5 || GND | ||
| | |||
| | |||
|} | |} | ||
==== | ==== EHCI ==== | ||
The accessory port found only on the original Vita models is a custom port USB interface. The port must be activated in software and so far, there does not seem to be any official public software that uses it. As of firmware 1.69, all APIs that reference the accessory port are permanently disabled. | |||
The only documented usage of this port is from an FCC filing for the PDEL-1001 development unit. It seems that some dongle attached to the device is used as part of their hardware testing framework. | |||
The | |||
The port appears to be the same as used on the Panasonic K1HA14AD0001. |