Editing PSP Street Jigkick
Jump to navigation
Jump to search
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 5: | Line 5: | ||
* Serial adapter must have a 1n4148 diode with line (cathode) toward it's TX, other end (anode) tied to RX, and RX going to Street USB ID pin | * Serial adapter must have a 1n4148 diode with line (cathode) toward it's TX, other end (anode) tied to RX, and RX going to Street USB ID pin | ||
* Ground connected between Street USB and serial adapter | * Ground connected between Street USB and serial adapter | ||
* (optional) Plug a 5v charger into the DC In port of the PSP Street | * (optional) Plug a +5v charger into the DC In port of the PSP Street | ||
Plug in your serial adapter to PC and set up [https://github.com/khubik2/pysweeper PySweeper] with the correct COM port for your adapter and the option for service mode selected. Plug in mini-B USB with only ID and ground connected to serial adapter into PSP Street while fully powered off (NOT in sleep mode), hold LTrigger + RTrigger + LeftDpad + Circle while powering on, SYSCON will begin serial communication with your serial adapter and enter service mode. | Plug in your serial adapter to PC and set up [[https://github.com/khubik2/pysweeper PySweeper]] with the correct COM port for your adapter and the option for service mode selected. Plug in mini-B USB with only ID and ground connected to serial adapter into PSP Street while fully powered off (NOT in sleep mode), hold LTrigger + RTrigger + LeftDpad + Circle while powering on, SYSCON will begin serial communication with your serial adapter and enter service mode. | ||
= Picture of Setup = | = Picture of Setup = | ||