Editing SAA-001
Jump to navigation
Jump to search
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 49: | Line 49: | ||
| Serial Flash || [[MX25L25635FMI-10G]] | | Serial Flash || [[MX25L25635FMI-10G]] | ||
|- | |- | ||
| Syscon || [[A01- | | Syscon || [[A01-C0L]] | ||
|- | |- | ||
| SATA || [[MB86C311B]] | | SATA || [[MB86C311B]] | ||
Line 70: | Line 70: | ||
* DDR3 bootup speed is 400MHz (DDR3-800, that is very low because DDR3 chip is rated for DDR3-1600). Not sure if DDR3 would go higher on fully booted unit). | * DDR3 bootup speed is 400MHz (DDR3-800, that is very low because DDR3 chip is rated for DDR3-1600). Not sure if DDR3 would go higher on fully booted unit). | ||
* unit denies to boot if I cut some of PCI-e lanes. Normally, x4 PCI-e interface would work on x1 lane without any problem (with lower bandwidth), but PS4 LED flashes blue forever if I cut PCI-e down to 1 lane. | * unit denies to boot if I cut some of PCI-e lanes. Normally, x4 PCI-e interface would work on x1 lane without any problem (with lower bandwidth), but PS4 LED flashes blue forever if I cut PCI-e down to 1 lane. | ||
{{Components}} | {{Components}} | ||
<noinclude>[[Category:Main]]</noinclude> | <noinclude>[[Category:Main]]</noinclude> |