Editing Boot modes
Jump to navigation
Jump to search
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 3: | Line 3: | ||
== Fan test == | == Fan test == | ||
The "fan test" mode allows to clean out the dust inside the PS3. When the PS3 boots in this mode the fan starts spinning in opposite direction and at 100% speed for | The "fan test" mode allows to clean out the dust inside the PS3. When the PS3 boots in this mode the fan starts spinning in opposite direction and at 100% speed for some minutes | ||
*How to enable fan test mode | Is reported to work for PS3 Models CECHG and newer, as shown in [[Thermal#Fan_settings_per_PS3_model_based_on_syscon_data_reads|this table]] | ||
**Turn power switch to the | |||
**Press and hold {{buttoneject}} button in the [[Switch_boards|Switch board]] | *<u>How to enable fan test mode</u> | ||
**Turn power switch to the | **PS3 Fat | ||
*** | ***Turn power switch to the OFF position (at the back of the console) | ||
***Press and hold {{buttoneject}} button in the [[Switch_boards|Switch board]] | |||
***Turn power switch to the ON position | |||
**PS3 Slim and SuperSlim | |||
***Disconnect the main power cable (at the back of the console) | |||
***Press and hold {{buttoneject}} button in the [[Switch_boards|Switch board]] | |||
***Connect the main power cable | |||
== Other special modes == | == Other special modes == | ||
The following requires the power switch in the back to be on: | The following requires the power switch in the back to be on: | ||
* Hold | * Hold Power button down for 6 seconds (while PS3 is on): turns off PS3. | ||
* Hold | |||
* Hold | * Hold Eject button down for 6 seconds (while PS3 is on): force disc to eject. | ||
* Hold Eject button down for 12 seconds (while PS3 is on): reset Blu-ray. | |||
* Hold | * Hold Power button down for two beeps (while PS3 is off): Reset video to lowest settings. | ||
* Hold | * Hold Power button down for three beeps (while PS3 is off): Enter PS3 diagnostic mode (repeat procedure twice) | ||
* Hold PS button down on controller for 10 seconds: Turns off Sixaxis or Dualshock 3. | |||
== JIG / Factory Service Mode / manufacturer == | == JIG / Factory Service Mode / manufacturer == |