SAA-001
Jump to navigation
Jump to search
- Seen in CUH-10xx series
- Productcode: 1-889-352-11 or 1-889-352-21
Gallery[edit | edit source]
SAA-001 - backside
SAA-001 - componentside
SAA-001 - componentside
SAA-001 - backside
PS4 Motherboard SAA-001 - main component side
PS4 Motherboard SAA-001 - back side
SAA-001 componentside - wm
SAA-001 backside - wm
SAA-001 componentside - image2984
SAA-001 componentside - image2984
SAA-001 componentside - image2984
SAA-001 componentside - image2984
SAA-001 componentside - image2984
SAA-001 componentside - image2984
SAA-001 componentside - image2990
SAA-001 componentside - image2991
- SAA-001 - Backside - IMG 2992.JPG
SAA-001 backside - image2992
SAA-001 backside - image2993
SAA-001 backside - image2994
SAA-001 backside - image2995
SAA-001 backside - image2996
SAA-001 backside - image2997
SAA-001 backside - image2998
Components[edit | edit source]
| Component | Package |
|---|---|
| APU | CXD90026G |
| APU RAM | K4G41325FC-HC03 |
| Southbridge | CXD90025G |
| Southbridge RAM | K4B2G1646E-BCK0 |
| Serial Flash | MX25L25635FMI-10G |
| Syscon | A01-COL |
| SATA | MB86C311B |
| HDMI | MN86471A |
| LAN | 88EC060-NN82 |
| Wireless communication module | 88W8797 |
| BD-ROM | R8J32841FP1 |
| USB 3.0 Hub | GL3520 |
Notes on components[edit | edit source]
- APU to MC link is PCI-e Gen2 (5Gbit/s, 4 lanes)
- APU to BD-ROM is SATA I (1.5 Gbit/s)
- DDR3 bootup speed is 400MHz (DDR3-800, that is very low because DDR3 chip is rated for DDR3-1600). Not sure if DDR3 would go higher on fully booted unit).
- unit denies to boot if I cut some of PCI-e lanes. Normally, x4 PCI-e interface would work on x1 lane without any problem (with lower bandwidth), but PS4 LED flashes blue forever if I cut PCI-e down to 1 lane.
X-ray Silicon Pron[edit | edit source]
https://siliconpr0n.org/map/sony/saa-001/x-ray/
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
